Contact Tool

- April 8, 2020 at 10:34 am
  
  zed1234
  Subscriber
  
  Hello,
  
  Hello when I try to generete Initial Information in Contact Tool it does not give me any results. I am wondering what is wrong ? I try to find a mistake in contacts.
  
  Thank you very much.
- April 8, 2020 at 1:10 pm
  
  peteroznewman
  Subscriber
  
  Right click on the Initial Information item under the Contact Tool folder and Evaluate Initial Contact Status, then you will see results.
- April 8, 2020 at 2:44 pm
  
  zed1234
  Subscriber
  
  I know that, you can see the process on the picture I attached.
  
  However after finshing it does not show the results but stays as it is.
- April 9, 2020 at 11:24 am
  
  Aniket
  Forum Moderator
  
  what error do you get? Try unchecking the distributed solver and try again.
  
  -Aniket
  
  How to access Ansys Online Help Document
  
  How to show full resolution image
  
  Guidelines on the Student Community
  
  How to use Google to search within Ansys Student Community
- April 9, 2020 at 4:51 pm
  
  zed1234
  Subscriber
  
  I tried to uncheck it, still no results. It shows these 2 warnings.
- April 9, 2020 at 4:51 pm
  
  zed1234
  Subscriber
- April 15, 2020 at 7:00 am
  
  Aniket
  Forum Moderator
  
  Are you using Model assembly? If yes, can you check for the contact tool in the subassemblies and see if that works? Also, can you right click on the warning and see if it takes you to problematic objects?
  
  -Aniket
  
  How to access Ansys Online Help Document
  
  How to show full resolution image
  
  Guidelines on the Student Community
  
  How to use Google to search within Ansys Student Community