Consultation about NLPLWK

- July 17, 2024 at 2:56 am
  
  zzhang868
  Subscriber
  
  Hello everyone, I am wondering why the results from NLPLWK always show zero. Any suggestions would be appreciated.
- July 17, 2024 at 4:20 pm
  
  Mike Rife
  Ansys Employee
  
  Easiest answer is that the model did not produce any plastic strain...what do the strain and/or stress results show? Mike
- July 19, 2024 at 3:46 am
  
  zzhang868
  Subscriber
  
  Hi Mike, thanks for your feedback. The strain and stress show no-zero results. Do you have any suggestions on how to address the issue? Thanks!
- July 19, 2024 at 4:03 am
  
  Mike Rife
  Ansys Employee
  
  Zihan
  Can you prove that? Show a screen shot of the plastic strain.
- July 21, 2024 at 12:08 am
  
  zzhang868
  Subscriber
  
  Hi Mike, this is what I have from my side: These values are not zero.
- July 21, 2024 at 2:02 am
  
  Mike Rife
  Ansys Employee
  
  Zihan
  None of those are plastic strain. Please show that plastic strain is non zero.
- July 30, 2024 at 9:07 pm
  
  zzhang868
  Subscriber
  
  Hi Mike, sorry for the late response. Please find the plastic strain as follows:
- July 30, 2024 at 11:21 pm
  
  Mike Rife
  Ansys Employee
  
  Did you add a mesh method object and choose the "Sweep" method meshing with "Automatic Thin" or "Manual Thin" option?
- July 30, 2024 at 11:55 pm
  
  zzhang868
  Subscriber
  
  I see, let me check it. Thanks!
- July 31, 2024 at 2:18 am
  
  Mike Rife
  Ansys Employee
  
  If not that then we need more information on the model. Material model, mesh type, etc.