Learning Forum

[dharanimoka]

Hello, I have been trying to simulate a 3 phase Induction machine. While simulating the software assumes that the simulation is complete and stops the simulation. As can been seen from the picture attached, the simulation has not reached steady state, but the simulation assumes that the steady state has been reached and the simulation stops. 

Is there any settings though which we can stop the early termination of the simulation?

Thank you.

[NKC]

Hi dharanimoka,

It looks like, you need to change the stop time in your Analysis setup window.

 

Regards,

Navya

[dharanimoka]

Hi, thanks for the reply and yes, Simulation setup has stop time of 2s. But as you can see in the plot above, the simulation has stopped at around 1.6s. 

[dharanimoka]

I have attached the same picture with the message board. As you can see that I had to run the simulation so many times just so the smulation runs the complete time as specified in the analysis setup. Please, any help would be appreciated.

Thank you.