Ansys Products

Ansys Products

Discuss installation & licensing of our Ansys Teaching and Research products.

Co-Simulation Issues

    • Mathis Allen
      Subscriber

      I am having an issue with my Simulink/Twin Builder co-simulation where it won't initialize due to some problem with the meshing.  Any ideas on how I can fix this?  I am not able to turn off TAMU so I am unsure what to do.  The target machine is an IPMSM in Maxwell 2D.  The Twin Builder circuit is also shown below.

    • DELI
      Ansys Employee
      Hi, the error message is about meshing in Maxwell, could you uncouple with Simulink/Twinbuilder and just simulate in Maxwell first? Does it have any error message?
Viewing 1 reply thread
  • The topic ‘Co-Simulation Issues’ is closed to new replies.