-
-
November 6, 2024 at 7:37 amNiklas.weindelSubscriberHello,ÂIs it possible to choose a hex mesh or another mesh shape in Ansys Maxwell?Âmany thanks and best regards,Niklas
-
November 11, 2024 at 12:56 amTamami YamanakaAnsys Employee
Hello,
Ansys Maxwell uses tetrahedral mesh for 3D and triangular mesh for 2D as mesh shapes suitable for adaptive auto-meshing.
Please note that other mesh shapes are not supported.Tamami
-
Viewing 1 reply thread
- You must be logged in to reply to this topic.
Ansys Innovation Space
Trending discussions
- HFSS Incident Plane Wave excitement mode
- Simulation of capacitor combining eddy currents with displacement currents
- How to calculate eddy and hysteresis losses of the core?
- Ansys Maxwell 3D – eddy current
- How to determine initial position in motion setup
- dq graph non-conformity
- Simplorer+Maxwell Cosimulation results and Maxwell results mismatch
- Parametrizing coil “terminals” with coil geometry
- On-chip inductor design
- Maxwell circuit – PWM
Top Contributors
-
1406
-
599
-
591
-
550
-
366
Top Rated Tags
© 2025 Copyright ANSYS, Inc. All rights reserved.
Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.