-
-
March 4, 2020 at 4:12 pm
Massinissa
Subscriber
Hello everybody,
I am trying to conduct simulation of centrifugical pump, but as soon as I start the run, the solver crashes ( See attachment).
I tried to fix this problem using different solutions that I found in forums like: Refine the mesh, simply the geometry and test different combination of boundaries conditions but unsuccessful.
Dear readers, please if you have any idea that can help me, do not hesitate to post it.
Thank you in advance for any potential help.
-
March 5, 2020 at 6:04 am
Amine Ben Hadj Ali
Ansys EmployeeIs there any additional information in the out file? -
March 5, 2020 at 4:59 pm
Massinissa
SubscriberHello Amine, thank you for your reply.
I share you the complet repport of CFX slover run that you can find in the followwing link:
https://drive.google.com/file/d/1X8nRxy_uLJYT6AFU6t1nI1OT17Ud-_Xg/view
Attached screenshots of mutiples messages displayed.
NB: With reading repport, I seen that I choosed AIR in MATERIAL, in reality it's WATER. Even I have changed this parametre, I have the same error.
Best regards,
Massinissa.
-
- The topic ‘CFX SOLVER ERROR PUMP SIMULATION’ is closed to new replies.
- air flow in and out of computer case
- Varying Bond model parameters to mimic soil particle cohesion/stiction
- Eroded Mass due to Erosion of Soil Particles by Fluids
- Guidance needed for Conjugate Heat Transfer Analysis for a 3s3p Li-ion Battery
- Centrifugal Fan Analysis for Determination of Characteristic Curve
- I am doing a corona simulation. But particles are not spreading.
- Issue to compile a UDF in ANSYS Fluent
- JACOBI Convergence Issue in ANSYS AQWA
- affinity not set
- Resuming SAG Mill Simulation with New Particle Batch in Rocky
-
3862
-
1414
-
1231
-
1118
-
1015
© 2025 Copyright ANSYS, Inc. All rights reserved.