We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.
Ansys Innovation Courses

Ansys Innovation Courses

Provide feedback or ask questions related to the Ansys Innovation Courses content.
  1. All Channels
  2. Ansys Innovation Courses
  3. Car Projection Lamp Simulation using Ansys Speos Quiz Problem

Car Projection Lamp Simulation using Ansys Speos Quiz Problem

    • February 26, 2025 at 10:21 am
      hakanbozkurt.iztech
      Subscriber

      Hi,

      I have enrolled a course called "Car Projection Lamp Simulation using Ansys Speos".
      For the quiz tab, I haven't seen any warning about it's possible to take it 5 times.
      I couldn't succeed about the quiz and it says "You have already taken this quiz 5 time(s) and may not take it again."
      Because of it I can't complete the course, and it was a suggested course for a training that I participated.
      Could be there additional chance for me, to take the quiz again?

      Best Regards,
      Hakan Bozkurt

    • February 28, 2025 at 1:39 pm
      Omkar Kulkarni
      Ansys Employee

      Hello,

      We have reset the number of attempts for this course. Please check if you can attempt the quiz again.
      Wishing you the best of luck!

      Thanks & Regards.

Viewing 1 reply thread
  • You must be logged in to reply to this topic.
Ansys Innovation Space
Top Contributors

© 2025 Copyright ANSYS, Inc. All rights reserved.

Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.