Learning Forum

[William Wong]

I was watching the tutorial video "Cutter Bodies – Lesson 4, Part 1", and I followed the video while working on the discovery software. But at that point that I have to cut the overlapping bodies out from the volume, I couldn't find the "overlapping bodies" option. I wonder where I can find that. Attached is the screenshot of my work

[V.P]

Hi William,

If you cannot find it there, go to the Prepare tab on the top ribbon. There you can find an option called 'Interference'. You can use that tool to find the overlapping regions in the geometry. It is the same as the Overlapping tool.