- 
		
			- 
March 26, 2024 at 8:02 am
- 
March 26, 2024 at 8:33 amErKo Ansys EmployeeHi In case 2 you can scope the beam/line body vertex to the circular face located at the bottom of the blind hole. All the best Erik - 
March 26, 2024 at 12:12 pmJeonee SubscriberThank you so much 
 
- 
 
- 
Viewing 1 reply thread
	
- The topic ‘Bolt Modeling (Line Body)’ is closed to new replies.
                Innovation Space
                 
            
            
            Trending discussions
             
        
        - LPBF Simulation of dissimilar materials in ANSYS mechanical (Thermal Transient)
- Convergence error in modal analysis
- APDL, memory, solid
- Meaning of the error
- How to model a bimodular material in Mechanical
- Simulate a fan on the end of shaft
- Real Life Example of a non-symmetric eigenvalue problem
- Nonlinear load cases combinations
- How can the results of Pressures and Motions for all elements be obtained?
- Contact stiffness too big
            Top Contributors
             
        
        - 
                        
                        4167
- 
                        
                        1487
- 
                        
                        1358
- 
                        
                        1189
- 
                        
                        1021
            Top Rated Tags
             
        
        
    © 2025 Copyright ANSYS, Inc. All rights reserved.
            Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.
        
     You are navigating away from the AIS Discovery experience
You are navigating away from the AIS Discovery experience 
               
          