-
-
September 27, 2017 at 11:19 am
admin
Ansys EmployeeHow to avoid stair stepping when creating inflation layers?
-
October 17, 2017 at 8:41 am
cbhavsar
Ansys EmployeeA smaller Gap Factor results in less layer compression and could help to avoid stair stepping. The Gap Factor can be changed under 'Advanced Options' for Inflation in the global mesh settings (click on Mesh, in the Details of Mesh, expand 'Inflation', set 'View Advanced Options' to Yes).
-
Viewing 1 reply thread
- The topic ‘Avoid stair stepping when creating inflation layers’ is closed to new replies.
Ansys Innovation Space
Trending discussions
- air flow in and out of computer case
- Varying Bond model parameters to mimic soil particle cohesion/stiction
- Eroded Mass due to Erosion of Soil Particles by Fluids
- I am doing a corona simulation. But particles are not spreading.
- Guidance needed for Conjugate Heat Transfer Analysis for a 3s3p Li-ion Battery
- Centrifugal Fan Analysis for Determination of Characteristic Curve
- Issue to compile a UDF in ANSYS Fluent
- JACOBI Convergence Issue in ANSYS AQWA
- affinity not set
- Resuming SAG Mill Simulation with New Particle Batch in Rocky
Top Contributors
-
3882
-
1414
-
1241
-
1118
-
1015
Top Rated Tags
© 2025 Copyright ANSYS, Inc. All rights reserved.
Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.