We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.
General Mechanical

General Mechanical

Topics related to Mechanical Enterprise, Motion, Additive Print and more.
  1. All Channels
  2. General Mechanical
  3. Automatic fitting and trimming of parts in SС

Automatic fitting and trimming of parts in SС

    • March 23, 2025 at 10:19 am
      javat33489
      Subscriber

      Hello everyone. I need to calculate a large structure from different board sections. A total of 3000 elements. There are places where the boards penetrate each other due to a small offset, for example 0.1 - 0.5 mm. When calculating, such a bonded contact can give me an error. And some parts are too long and penetrate each other. The parts need to be shifted and trimmed, doing it manually takes a very long time.
      Please tell me if it is possible to perform automatic fitting and trimming of parts in Space Claim?

    • March 24, 2025 at 1:11 pm
      Akshay Singh
      Ansys Employee

      Hello,

      You can use the Interference Tool on the Prepare Tab of Spaceclaim to check for interfering geometries and take corrective action

      More help can be found here: Interference Tool

Viewing 1 reply thread
  • You must be logged in to reply to this topic.
Ansys Innovation Space

© 2025 Copyright ANSYS, Inc. All rights reserved.

Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.