Automated pattern generation: how to change the size (scale up or down)

[ferina.saati]

I am trying to figure out how it can be made possible that I create a pattern (fill pattern for instance) where the components are not identical. For example, generating a hole in the middle of a sheet and then creating a fill pattern where the holes become smaller the farther they are away from the center. As I understand, such feature does not exist. Would there be a way, however, to automate the sketch generation for example in a way that such pattern creation is possible?

[subashni.satish]

Hello Ferina,

Are you using Ansys Discovery or Ansys SpaceClaim?

You can try to use the Equation tool in the Design tab to derive a custom equation to be able to create this pattern.