TAGGED: workbench
-
-
September 26, 2023 at 7:30 pmdhruvi dhairya patelSubscriber
In my workbench I can not able to see the Maxwell 2D and Maxwell 3D option. I only can see fluent and structural options. Can you please tell me how I can couple the Maxwell with Ansys workbench?
-
September 27, 2023 at 10:58 amTimosAnsys Employee
Hello, you should run (as administrator) Modify Integration with Ansys 202x Rx. Once you complete this step, launch Workbench. You will see Maxwell and other Electronics solvers in the analysis system.
-
Viewing 1 reply thread
- The topic ‘Ansys Workbench’ is closed to new replies.
Ansys Innovation Space
Trending discussions
- HFSS Incident Plane Wave excitement mode
- Ansys Maxwell 3D – eddy current
- How to calculate eddy and hysteresis losses of the core?
- Simulation of capacitor combining eddy currents with displacement currents
- dq graph non-conformity
- Simplorer+Maxwell Cosimulation results and Maxwell results mismatch
- Parametrizing coil “terminals” with coil geometry
- On-chip inductor design
- Maxwell circuit – PWM
- Calculating E-field tangential to a 2D resonant structure on a sapphire chip
Top Contributors
-
1727
-
630
-
599
-
591
-
366
Top Rated Tags
© 2025 Copyright ANSYS, Inc. All rights reserved.
Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.