Ansys maxwell, rmxprt axial flux motor 3 phase current

- November 25, 2024 at 6:58 am
  
  wonseiii99
  Subscriber
  
  Hi, I am performing a simulation of applying 3 phase AC to an axial flux motor. I checked that PHASE A B C shown in the picture are grouped into Winding group, but below it says Stator current, so shouldn't it actually be Winding current? I wonder if this setting is correct.
  Thanks for your reply
- November 25, 2024 at 12:51 pm
  
  Timos
  Ansys Employee
  
  Hi, "Stator Currents" is simply the title-name of the plot. The plotted values represent the Currents of PhaseA, PhaseB, PhaseC.