3D Design

3D Design

Topics related to Ansys Discovery and Ansys SpaceClaim.
  1. All Channels
  2. 3D Design
  3. Ansys HFSS Box cannot be created in coordinate system using post process variable

Ansys HFSS Box cannot be created in coordinate system using post process variable

    • March 18, 2019 at 9:44 pm
      kjohnson10
      Subscriber

      Good Evening,


       


      I was trying to draw a rectangular prism on an sma connector for an internal conductor pin, but because I am using a relative coordinate system with definitions linked to a post processing variable, I cannot.


      Please share any insight if you have the time.


      Thank you


      error message

    • October 10, 2019 at 6:11 pm
      Sorceress Gia
      Ansys Employee

      Create an addition coordinate system that isn't linked to a post processing variable...

Viewing 1 reply thread
  • The topic ‘Ansys HFSS Box cannot be created in coordinate system using post process variable’ is closed to new replies.
Innovation Space
Top Contributors

© 2025 Copyright ANSYS, Inc. All rights reserved.

Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.