-
-
May 4, 2025 at 5:03 pm
Hasan
SubscriberNew to this and learning reduced errors but still have this problem while setting valve inputs. A spark ingnition two valve enigne. Probably other errors too, there is a gap in the CAD model between the valve seat and the valve face of 0.5 mm. In the inputs IÂ Â Exceeded limit of 500 iterations, please check boundary condition settings.
Ignoring update of min_lift because it is currently a Workbench parameter.
It must only be updated from Workbench. Â -
May 4, 2025 at 5:05 pm
-
May 4, 2025 at 5:17 pm
Hasan
SubscriberEverytime I enter seat_exhaust and Exhaust_valve_near_seat_surface in the bottom left seletion, the latter disappears once I select Apply and then save, as shown above.Â
-
May 4, 2025 at 5:36 pm
-
July 14, 2025 at 2:56 pm
Hasan
SubscriberAnother question, I got an error message saying I can't run this tutorial because the fuel library isn't license for academic application. See link below for duel fuel simulation chapter 3 tutorial.
How can I get pass this? Is there a file which can perform similar duel fuel combustion in ANSYS Forte academic? Another chemistry file (.cks ) which does similar gasoline and diesel combustion as in tutorial chapter 3.
-
- You must be logged in to reply to this topic.
-
3492
-
1057
-
1051
-
955
-
922
© 2025 Copyright ANSYS, Inc. All rights reserved.