-
-
February 22, 2023 at 8:03 am
Teo Wei Xiang
SubscriberI am trying to analysis a flow through a rectangular pocket design but when I state my BCs as mass flow rate inlet and pressure outlet. It is unable to solve while when I state pressure or velocity inlet, the model can be solve. May I know what I did wrong?
An example when I try to initialize a mass flow rate inlet vs velocity inlet. Both has a pressure outlet BCs.
Â
-
February 22, 2023 at 8:07 am
Teo Wei Xiang
SubscriberI just realise what I did wrongly, I did not specific the correct direction specification method.
-
Viewing 1 reply thread
- The topic ‘Ansys Fluent unable to solve with Mass Flow Rate Inlet BCs’ is closed to new replies.
Ansys Innovation Space
Trending discussions
- air flow in and out of computer case
- Varying Bond model parameters to mimic soil particle cohesion/stiction
- Eroded Mass due to Erosion of Soil Particles by Fluids
- Guidance needed for Conjugate Heat Transfer Analysis for a 3s3p Li-ion Battery
- I am doing a corona simulation. But particles are not spreading.
- Issue to compile a UDF in ANSYS Fluent
- Centrifugal Fan Analysis for Determination of Characteristic Curve
- JACOBI Convergence Issue in ANSYS AQWA
- affinity not set
- Resuming SAG Mill Simulation with New Particle Batch in Rocky
Top Contributors
-
3862
-
1414
-
1236
-
1118
-
1015
Top Rated Tags
© 2025 Copyright ANSYS, Inc. All rights reserved.
Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.