-
-
May 14, 2024 at 6:50 amGrigor NikolovSubscriber
Hi all
is it possible to create iso-clip surface for particle injection in VOF model. I did but i cant see it in injection surfaces
best regards Grigor
-
May 15, 2024 at 1:44 pmPrashanthAnsys Employee
Hi, I don't think iso-clips can be made into injection surfaces. You can use injection file instead.
-
Viewing 1 reply thread
- The topic ‘ANSYS FLUENT CUSTOM INJECTION SURFACE’ is closed to new replies.
Ansys Innovation Space
Trending discussions
- How do I get my hands on Ansys Rocky DEM
- Non-Intersected faces found for matching interface periodic-walls
- Fluent fails with Intel MPI protocol on 2 nodes
- Unburnt Hydrocarbons contour in ANSYS FORTE for sector mesh
- Help: About the expression of turbulent viscosity in Realizable k-e model
- Cyclone (Stairmand) simulation using RSM
- Mass Conservation Issue in Methane Pyrolysis Shock Tube Simulation
- Facing trouble regarding setting up boundary conditions for SOEC Modeling
- Script Error
- convergence issue for transonic flow
Top Contributors
-
1727
-
624
-
599
-
591
-
366
Top Rated Tags
© 2025 Copyright ANSYS, Inc. All rights reserved.
Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.