Learning Forum

[Raphael Wiederkehr]

Hey, I installed Ansys yesterday. The geometrie, mesh and setup works fine. But when I start the solver it gets a erroer message like this:

 

ANSYS-LIZENZMANAGERFEHLER

 

Maximum licensed number of demo users already reached.

Dependent feature cfd_base in AND keyword is not available.

 

 

 License ID:     License checkout failed (CFD SOLVER).

 

ANSYS LICENSE MANAGER ERROR

 

Maximum licensed number of demo users already reached.

Dependent feature cfd_base in AND keyword is not available.

 

 

 

 +--------------------------------------------------------------------+

 | ERROR #001100247 has occurred in subroutine .                      |

 | Message:                                                           |

 |                                                                    |

 | The solver is unable to continue because of licensing problems.    |

 |                                                                    |

 | A license for the following capability level could not be checked  |

 | out:                                                              

Can your help me with the problem?

kind regards

[ANSYS_MMadore]

Are you trying to run the solver while you have another instance of the application open for Pre/Post processing? If so, you can only have 1 active session.

[Raphael Wiederkehr]

Thank´s you are right (: (: (:

I´m was used to the licence of my university....

 

Thanks (: