-
-
September 12, 2023 at 9:03 pm
-
September 13, 2023 at 10:42 am
dushyant.marathe
Ansys EmployeeÂ
Hi Imtiaz,
Thanks for posting your query on Ansys Learning Forum !
You can change X and Z axis by changing angle Theta in above definition. Please try changing Theta value to 45 degree or 90 degree and this should change the X and Z axis keeping Y in same direction.
Thanks.
Â
-
Viewing 1 reply thread
- The topic ‘Alter an X and Z axis without altering the Y axis in HFSS?’ is closed to new replies.
Ansys Innovation Space
Trending discussions
- Y wiring method and the start and end points of winding.
- Lumped Port Deembed
- Hfss 3D pcb via capped and filled with epoxy
- Optimizing Via Impedance in Ansys HFSS 3D Layout Using Geometric Parameter Sweep
- AEDT Natural Convection with default correlation is failing solver initializatio
- HFSS libnvidia-ml.so too old or could not be found – Warning in slurm job output
- Three-Phase Voltage Imbalances in dual stator electric generator
- STL Import Errors in HFSS After Cleaning in SpaceClaim
- Calc Error in Field Calculator after PyAEDT Analyze
- import file autocad 3d
Top Contributors
-
3862
-
1414
-
1220
-
1118
-
1015
Top Rated Tags
© 2025 Copyright ANSYS, Inc. All rights reserved.
Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.