We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.
General Mechanical

General Mechanical

Topics related to Mechanical Enterprise, Motion, Additive Print and more.
  1. All Channels
  2. General Mechanical
  3. ACP: How can I run a postprocessing with two composite parts as one integrated part?

ACP: How can I run a postprocessing with two composite parts as one integrated part?

    • February 16, 2021 at 8:06 pm
      siderite
      Subscriber

      Hello everyone,

      I am now working with Ansys ACP post-processing. As you can see in the picture below, I have combined two composite parts in the Static Structural Analysis system by assigning them a contact. 

      The problem is that I want to show the postprocessing result of the combined part, not separately as in the picture where I marked it with yellow. 

      Is there any way to show the postprocessing result of two parts at the same time?

      image.png
    • February 18, 2021 at 1:14 pm
      peteroznewman
      Subscriber
      Like this?n
    • September 28, 2023 at 9:02 pm
      ariel.lusty
      Subscriber

       

      I had a similar problem and tried peteroznewman's solution but only one of the plies from each ACP setup show up in the solo Mechanical Model, creating an unwanted gap between the two parts. Does anyone know how to get all of the plies to show up when combining multiple parts? 

Viewing 2 reply threads
  • The topic ‘ACP: How can I run a postprocessing with two composite parts as one integrated part?’ is closed to new replies.
Ansys Innovation Space

© 2025 Copyright ANSYS, Inc. All rights reserved.

Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.