3D Meshing

- July 21, 2020 at 9:53 am
  
  raju.chowdhury
  Subscriber
  
  Hi,
  
  I am meshing using edge sizing (number of divisions). what could be the reason of deforming (see the red marked zone) the mesh line instead of being straight line? I am expecting that all lines will be straight lines. How can I solve this?
- July 21, 2020 at 2:45 pm
  
  Rob
  Forum Moderator
  
  It'll be a conflict between size and growth as you have a very fine mesh at the centre. I'd not worry about it. Instead check the jump in cell size between the top & next to top volumes. As a thought, look at pave meshes and sweeping in the axial direction.