TAGGED: analysis, constraints, contact, error, mechanical
-
-
December 16, 2024 at 6:29 am
ganesh.shinde
Subscriber -
December 16, 2024 at 2:42 pm
Harshvardhan
Ansys EmployeeHi,
Changing the contact formulation from Program Controlled to Augmented Lagrange might help you out with this error.I hope this helps.
Regards,
Harshvardhan
Ansys Help
Ansys Learning Forum (Rules & Guidelines)
-
Viewing 1 reply thread
- You must be logged in to reply to this topic.
Ansys Innovation Space
Trending discussions
- The legend values are not changing.
- LPBF Simulation of dissimilar materials in ANSYS mechanical (Thermal Transient)
- Convergence error in modal analysis
- APDL, memory, solid
- How to model a bimodular material in Mechanical
- Meaning of the error
- Simulate a fan on the end of shaft
- Nonlinear load cases combinations
- Real Life Example of a non-symmetric eigenvalue problem
- How can the results of Pressures and Motions for all elements be obtained?
Top Contributors
-
3882
-
1414
-
1241
-
1118
-
1015
Top Rated Tags
© 2025 Copyright ANSYS, Inc. All rights reserved.
Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.