1D SOLID ELEMENT

- September 3, 2023 at 7:26 pm
  
  ROHITH
  Subscriber
  
  IS THERE ANY POSSIBILITY OF DOING AN ANALYSIS ON A LINE ELEMENT BY APPLYING A SOLID SQUARE SECTION(100*100) AS THE DISCOVERY 2023 HAS ALL HOLLOW CROSS SECTIONS TO APPLY TO MY 1D ELEMENT.
- September 4, 2023 at 7:16 am
  
  ErKo
  Ansys Employee
  
  Hi
  The only way I found is to create a 3D solid (with 100 x 100 section), then use the extract tool in discovery (Prepare tab) and that will create a new extracted beam section which you can then use on your model so the rest of the lines and assign this section to them.
  All the best
  Erik