We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › 3D Design › Convergence criteria is not met while running CHT analysis in Refine mode of ANSYS Discovery 2021 R1. › Re: Convergence criteria is not met while running CHT analysis in Refine mode of ANSYS Discovery 2021 R1.

July 24, 2021 at 1:37 pm
prathap
Subscriber

Hello Subashni

I hope the problem setup was good to solve. An error free solution from your end will help to solve problems with similar setup.