We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Probe – x,y,z coordinates › Reply To: Probe – x,y,z coordinates

November 10, 2017 at 7:51 am
momidor
Subscriber

Hi,


In the past I saw tha table on left dow corner with: probe values and XYZ coordiantes. All this valuse have been appearing simulataneusly always when I was clicking the "probe" button.. Â