We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › 3D Design › Geometry editor was closed abnormally › Reply To: Geometry editor was closed abnormally

November 1, 2017 at 7:38 pm
Jheferson_ga
Subscriber

hello. I have the same problem too, when I start a new project of Design Assessment the second step is make a geometry to work, but at the moment of start the SpaceClaim, Ansys shows that message. then I close it and can make my figure, but when came back to the Workbench... it doesn't receive the archive.Â