We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Change decimal point value for probe pointer › Reply To: Change decimal point value for probe pointer

October 17, 2017 at 10:21 am
cbhavsar
Ansys Employee

We can change number of significant digits for probe pointer by setting the required value at following location under Project Schematic page; Tools//Options//Appearance//Number of Significant Digits Default value is 5.