We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Convergence problem › Reply To: Convergence problem

October 11, 2017 at 11:53 pm
pgl
Ansys Employee

Is the structural analysis nonlinear, transient etc? If you could share some screenshots and an outline of the structural simulation that would be easier for the community to help diagnose compared to an *.out.


Note that there can be many reasons for non-convergence,  the online doc. provide a lot of guidance...Here's the section on nonlinear controls as starting point. 


Plus here's a convergence troubleshooting guide available in the online doc.Â