We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › Electronics › Can’t run electromagnetics in AIM › Reply To: Can’t run electromagnetics in AIM

September 27, 2017 at 3:22 pm
rexxar
Subscriber

I have same problem too, same error like ECEPSU have. I have try two simuluation, in both i have same error. When i start a new project, import geometry file and when i go to "Physics" then show error.