We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Installation and Licensing › Ansys Free Student Software › ANSYS AIM – Getting around student license geometry size restriction › Reply To: ANSYS AIM – Getting around student license geometry size restriction

September 8, 2017 at 1:16 am
pgl
Ansys Employee

The Student products have node, element and geometry limits. The geometry limits are 50 bodies and 300 Faces.


Can you share a screenshot of your geometry?


For the meshing in ANSYS AIM Student, take a look at the product documentation, there's a section on Setting Mesh Sizes to Optimize Performance that provides some very good advice.Â