Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › temperature loads – too much penetration and element turning upside down › Reply To: temperature loads – too much penetration and element turning upside down
December 19, 2024 at 4:55 pm
Subscriber
Hi Ashish,
I tried with Programme control mesh, the solution is not converging. It is bisecting in first iteration and then run turminates.
Defromation of unconverged solution is also very high. Â
Solution not converged at time 5.E-03 (load step 1 substep 1).        Â
 Run terminated.Â