We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › Preprocessing › Solutions for “A software execution error occurred inside the mesher.” in 2D › Reply To: Solutions for “A software execution error occurred inside the mesher.” in 2D

December 17, 2024 at 4:24 pm
Rob
Forum Moderator

The old limit was around 100k, that is likely to have changed but I've never seen it reported in the release notes. Try breaking the face down a bit more and start with the finer mesh region. Or use a coarser mesh and review adaption in the Fluent solver.