We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › How can we consider specific modes in modal analysis for expansion in MSUP RV? › Reply To: How can we consider specific modes in modal analysis for expansion in MSUP RV?

December 16, 2024 at 9:03 am
BALA
Subscriber

 

Hi all,

i did some modification as per the syntax, i run the simulation again but still same error,

the code which have used is given below 

antype,modal
modopt,lanb,20
mxpand,none
SOLVE
FINISH
!
/SOLU
antype,modal,restart
mxpand,,,,YES,,YES,EFFM,,
modseloption,0.9,no,no,no,no,no,
SOLVE

following is the error

for above code i have referred this discussion content

https://innovationspace.ansys.com/knowledge/forums/topic/how-can-we-consider-only-specific-modes-in-the-harmonic-analysis-based-on-the-modal-participation-factor-in-modal-analysis/