We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Gaps in self-made car jack › Reply To: Gaps in self-made car jack

November 21, 2024 at 11:58 am
kubatycjan
Subscriber

 

Thank you very much for Your response Harshvardhan, what kind of 3D software you propose to rectified those two parts ( sidebase 1 and 2) ?

Speaking of which why should I use joints ? Since I want my model to be immovable during analysis. I want to set my car jack on definied height and then see how force of 2T works on my tool 

Â