We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › Fluids › How do I create this type of Mesh › Reply To: How do I create this type of Mesh

November 7, 2024 at 5:15 pm
ae22b001
Subscriber

I tried it in Ansys meshing itself, In the geometry designer, I split the face into multiple parts. Then i meshed the faces separately. The only problem is that now when I open it in fluent, the interfaces between the faces cannot be set as interior. What should I do 
CDN media