We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › How to apply Compression-only Support? › Reply To: How to apply Compression-only Support?

November 4, 2024 at 11:07 am
M210098
Subscriber

Hi,

If that is the case, is there a need to also apply frictionless contact? Or we can just apply one? As they both have the same function.Â