We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › Optics › Tolerancing compensator limits exceeded in Monte Carlo runs › Reply To: Tolerancing compensator limits exceeded in Monte Carlo runs

October 31, 2024 at 9:03 am
Niki Papachristou
Ansys Employee

Hi Jurgen,

Thank you for reaching out to us! May I ask you wether you have gone through our help page: The Tolerance Tab » Tolerancing Group » Tolerance Data Editor » Tolerance Control Operands » General Comments About Min & Max Values on Compensators? I believe you might find the reason why the min/max values are violated there. That being said, if you have further question on this topic feel free to come back!

Kind Regards,

Niki