We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › Fluids › ELES setup › Reply To: ELES setup

October 24, 2024 at 3:51 pm
M_abati
Subscriber

 

 

The red box is the body of influence geometry, I am simulating a bluff body (square cylinder). I have not applied periodicity on the sides/top. Is it not possible to accurately simulate without periodicity?

Â