We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Grain Sizes Analysis › Reply To: Grain Sizes Analysis

October 24, 2024 at 11:31 am
Erik Kostson
Ansys Employee

Hi

We do not have such a module.

Perhaps doing a literature review on this topic might give some ideas of different numerical tools if any, that might be used for this. 

All the best

Erik