We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › LS Dyna › How to view a contour of the contact pressure in lsprepost › Reply To: How to view a contour of the contact pressure in lsprepost

October 14, 2024 at 2:09 pm
igandiko
Ansys Employee

You can check it using intfor database. intfor is a binary database and requires "s=" be used on the execution line to identify the actual name of the intfor database (see *DATABASE_BINARY_INTFOR and *DATABASE_EXTENT_INTFOR to control the content of intfor to some extent).