We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › Optics › Issue when evaluating Ansys Academic Research Optics License › Reply To: Issue when evaluating Ansys Academic Research Optics License

October 3, 2024 at 5:47 pm
jrf
Subscriber

 

No its not just the performance diagnostic window, but this behavior is also seen within all optimization windows (local, hammer, global). Tolerancing and non-sequential raytrace windows seem to be OK. I am already running the lastest version of 2024 R2.02 and did a repair on the installation files with no change in behavior. I also see this behavior across two different workstations. 

What is odd is that the behavior is related to the license version I run. If I run my current subscription license “Ansys Zemax OpticStudio Premium” everything behaves normally. If I run the evaluation license “Ansys Academic Research Optics” I see this behavior.  

I will do a complete un-install and re-install of Ansys Zemax OpticStudio 2024 R2.02 and see if that changes anything.

Best,

Jason