We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Stresses and Deformation in Ansys Motion Standalone › Reply To: Stresses and Deformation in Ansys Motion Standalone

September 18, 2024 at 9:04 am
zabee.k
Subscriber

Hi Ankush,

 

Thanks for the reply. Do we have any option to call out for stresses and deformation like we do in ansys mechanical or by default we will get results?

Would it be possible for you to check the setup of my file and guide me how to get the results. Can i share you a link to google drive here? or if you could share me your simulation file so that i can see and understand what went wrong with me.

Thank you for your support!

 

Regards,

Zabee Khan