We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › 3D Design › Lower the minimum length than 50nm › Reply To: Lower the minimum length than 50nm

September 16, 2024 at 3:47 pm
dkook3
Subscriber

 

I am currently just working on workbench (cell D)

 

I don't understand the question well since I am not solving anything, just generating geometry.

 

Could you tell me where should I look to see what solver I am using in geometry?

 

Thank you.