We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › Preprocessing › Too High Aspect Ratio › Reply To: Too High Aspect Ratio

September 13, 2024 at 1:34 pm
Rob
Forum Moderator

Did you set the whole, and all face size at 0.002? Also, if you have any proximity/curvature functions active you could have smaller/larger surface facets due to the geometry. If you plot the poor cells where are they?