Ansys Assistant will be unavailable on the Learning Forum starting January 30. An upgraded version is coming soon. We apologize for any inconvenience and appreciate your patience. Stay tuned for updates.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Stresses and Deformation in Ansys Motion Standalone › Reply To: Stresses and Deformation in Ansys Motion Standalone

September 10, 2024 at 6:22 pm
Ankush Choudhary
Ansys Employee

Hi,

If you are setting up the model correctly and it is running fine, then you will have the stress and deformation values on the flexible body in motion post as shown below.

[bingo_chatbox]