We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › 3D Design › How to perform a strength analysis of 3D printed parts › Reply To: How to perform a strength analysis of 3D printed parts

September 4, 2024 at 12:16 am
konishi
Subscriber

 I've managed to perform the analysis, but I'm still struggling with how to set the material properties.

In the case of 3D printing, there is a tendency for the material to delaminate and fail along the layer direction. Is there a way to reflect this in the analysis? Can anisotropic material settings not be used?