We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum Forums Discuss Simulation 3D Design How to perform a strength analysis of 3D printed parts Reply To: How to perform a strength analysis of 3D printed parts

Devendra Badgujar
Forum Moderator

Hello Konishi, 

Can you please elaborate your question to understand this better? Is there any specific condition you want to define in Ansys Discovery for analysis? 

Regards,

DevendraÂ