We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › 3D Design › Block Recording in Sheet Metal › Reply To: Block Recording in Sheet Metal

August 29, 2024 at 11:00 am
Devendra Badgujar
Forum Moderator

Ansys Discovery is now the primary geometry application to create, import, and prepare geometry for simulation. Sheetmetal capabilities might be there in future releases, we don't have timeline for it yet. 

You can refer Ansys Discovery for Geometry Preparation - Ansys Knowledge documetnation for more information. 

Regards,

DevendraÂ