We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Hotspot shifts after slicing for sweep mesh › Reply To: Hotspot shifts after slicing for sweep mesh

August 27, 2024 at 7:44 pm
Subash Niraula
Subscriber

Hello Ashish,

the link is not showing in your reply. Could you please post it again. Thanks.

Regards

subash